Samsung CO88R Service Manual page 9

Disassembly and Reassembly
4-4 Replacement of Temperature Seneor
1. Remove the wiring(CN3).
2. Remove the screw(1 piece) for temperature
sensor attachment.
3. Remove the temperature sensor.
4-5 Replacement of Gas Sensor
1. Remove the screw for the sensor attachment
on the back of exhaust duct.
2. Remove the gas sensor from the housing.
4-6 Replacement of Upper Heater
1. Remove the wiring.
2. Remove the screws(five pieces) for Bkt-cover
heater(u) setting.
3. Remove the heater attachment nut(2) with
7mm driver. (Then the gasket stopper and
gasket get apart)
4. Press the plate to remove the support-
heater(two pieces).
5. Remove the upper heater.
PLATE SPRING
*Hold on A part and push in direction of B.
*Assembly procedure of gasket
UPPER HEATER
GASKET
4-2
(Bkt-cover heater(U), Gasket stopper,Gasket, Plate spring, Support heater)
A
B
SUPPORT-HEATER
GASKET GASKET
CAVITY
STOPPER
BKT-cover heater(U)
attachment screw
(5 pieces)
Upper heater(U)
Plate spring attachment nut
(2 pieces)
Support-
Heater
Temperature sensor
Temperature sensor
attachment screws
GAS sensor
GAS sensor
attachment screws
BKT-cover heater(U)
Samsung Electronics