Linksys SRW224G4P User Manual page 14

Chapter 4
You can add up to five user accounts in addition to the
default admin account . The admin account cannot be
deleted from the system .
To save the new user account information, use the arrow
keys to select Save and press Enter .
IP Configuration
The IP Configuration screen displays four menu choices:
IP Address Settings, HTTP/HTTPS, SNMP, and Network
Diagnostics .
IP Configuration
IP Address Settings
The IP Address Settings screen allows you to set the IP
information for the Switch .
IP Address Configuration
IP Address This sets the Switch's IP Address . The default
setting is 192 .168 .1 .5 .
Subnet Mask This combined with the IP Address defines
the Switch's network address .
Default Gateway This defines the IP Address for the
default gateway of the network .
24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
Configuration Using the Console Interface
Management VLAN
Management VLAN . This is the only VLAN through which
you can gain management access to the Switch . By
default, all ports on the Switch are members of VLAN 1,
so a management station can be connected to any port
on the Switch . However, if other VLANs are configured
and you change the Management VLAN, you may lose
management access to the Switch . In this case, you should
reconnect the management station to a port that is a
member of the Management VLAN .
WARNING:
Do not define the Management
VLAN as a VLAN that has yet to be created . If
the VLAN does not exist already, the software
will automatically create the VLAN but will not
assign VLAN membership . If this happens, the
Switch cannot be managed via the web-based
utility until it has been reconfigured via the
console interface .
IP Mode
Choose to have either a user-defined IP address
or to have it assigned by DHCP or BOOTP .
HTTP/HTTPS
The HTTP/HTTPS screen allows you to set the Hyper Text
Transfer Protocol server (web server) information for the
Switch .
HTTP Server Enable or disable the Switch's HTTP server
function .
HTTP Server port
Set the TCP port that HTTP packets are
sent and received from .
HTTPS Server Enable or disable the Secure HTTP server
function of the Switch .
HTTPS Server port Set the TCP port that the HTTPS
packets are sent and received from .
SNMP
The SNMP screen allows you to set the Switch's SNMP
settings .
Set the ID number of the
HTTP/HTTPS
10