Using In Upright Mode; Cleaning The Motorised Floor Brush - Morphy Richards SuperVac User Manual

VC70485MUK Rev2_Instruction Booklet 28/07/2011 16:10 Page 4

Using in upright mode

1 Lift the assembled upright vacuum cleaner off
the charging cradle Ê.
2 Turn the product On by using either the upright
On/Off button ¤ or the handheld vacuum
cleaner On/Off button ·. The handheld
vacuum cleaner power indicator light ‚ and
the floor brush power indicator light Ë will
illuminate.
Whichever On/Off button you use, you must
use the same button to turn the vacuum
cleaner off . In addition, both the upright and
handheld vacuum cleaner On/Off buttons must
be in the Off position for the vacuum cleaner to
be off.
3 After use, return the upright vacuum cleaner to
the charging cradle Ê.
NOTE: If use is continued until the battery level
reaches a minimum set level, the product will
automatically stop and must be recharged.
NOTE: If used on longer pile carpets for an
extended period, it is possible the brush bar
protection system will operate, disabling the
motorised floor brush È. In this event, switch
the vacuum cleaner off for five minutes before
reusing.
Cleaning the motorised floor
brush
1 Unplug the cleaner from the mains switch.
To separate the motorised floor brush È from
2
the main vacuum cleaner body ›, press the
floor brush release button  and pull the floor
brush away F.
F
3 Turn the floor brush over to inspect the brush
bar.
4 Using a coin, turn the locking button on the
brush bar cover anti-clockwise from the
position to the
G
UK Helpline 0844 871 0960
4
position G.
Replacement Parts 0844 873 0726
5 Remove the brush bar end cover and lift the
brush bar out H.
H
6 Pull away any hairs or fibres from the brush
bar. If they are tightly wound around the brush,
carefully snip the fibres with scissors, being
careful not to damage the rotating brush bar,
pull away from the rotating brush bar and
dispose of.
HANDHELD VACUUMING
This function is ideal for cleaning stairs,
curtains, upholstery and hard to reach places.
To separate the handheld vacuum cleaner fi
1
from the main vacuum cleaner body ›, press
the handheld vacuum cleaner release button
fl and pull the handheld vacuum cleaner away
from the main vacuum cleaner body I.
I
2 After use, return the handheld vacuum cleaner
to the cavity on the main vacuum cleaner body
by firstly sliding the suction end into place over
the suction hole in the main vacuum cleaner
body cavity, then push the handle end in to
place until a click is heard.
Ireland Helpline 1800 409 119