Chapter 3: Installation; Overview; Pre-Installation Considerations; Full-Duplex Considerations - Linksys SLM2005 User Manual

Business series 5-port and 8-port 10/100/1000 gigabit smart switch with pd and ac power
Hide thumbs Also See for SLM2005:
Table of Contents

Advertisement

Chapter 
Chapter :
Installaton

Overview

This chapter will explain how to connect network devices
to the Switch. The following diagram shows a typical
network configuration.
Cable/DSL
Internet
Modem
Router
Powered by
Desktop
Notebook
Switch
Typical Network Configuration
When you connect your network devices, make sure you
don't exceed the maximum cabling distance of 100 meters
(328 feet).
5-Port and 8-Port 10/100/1000 Ggabt Smart Swtches wth PD and AC Power
Wireless Access
Point
Server

Pre-Installation Considerations

Full-Duplex Considerations

The Switch provides full-duplex support for its RJ-45
ports. Full-duplex operation allows data to be sent and
received simultaneously, doubling a port's potential data
throughput. If you will be using the Switch in full-duplex
mode, the maximum cable length using Category 5 cable
is 328 feet (100 meters).

1000BASE-T Cable Requirements

All Category 5 UTP cables that are used for 100BASE-TX
connections should also work for 1000BASE-T, providing
that all four wire pairs are connected. However, it is
recommended that for all critical connections, or any
new cable installations, Category 5e (enhanced Category
5) or Category 6 cable should be used. The Category
5e specification includes test parameters that are only
recommendations for Category 5. Therefore, the first
step in preparing existing Category 5 cabling for running
1000BASE-T is a simple test of the cable installation to be
sure that it complies with the IEEE 802.3ab standards.

Positioning the Switch

Before you choose a location for the Switch, observe the
following guidelines:
Make sure that the Switch is accessible and that the
cables can be connected easily.
Keep cabling away from sources of electrical noise,
power lines, and fluorescent lighting fixtures.
Position the Switch away from water and moisture
sources.
To ensure adequate air flow around the Switch, be
sure to provide a minimum clearance of two inches
(50mm).
Do not stack free-standing Switches more than four
units high.
Installation


Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Slm2008

Table of Contents