Security > 802.1X Parameter; Security > Static Mac Address; Security > Management Access List - Linksys SLM2005 User Manual

Chapter 
RADIUS UDP Port Enter the UDP Port of the server. The
UDP port is used to verify the RADIUS server authentication.
The default value is 181.
Key Strng Enter the secret key string as defined on
the RADIUS server. The secret key string is used for
authenticating and encrypting communications between
the device and the RADIUS server.
Admn State Sets the authentication mode to one of the
following options:
• Auto Requires a dot1x-aware client to be authorized
by the authentication server. Clients that are not
dot1x-aware will be denied access.
Force-Authorzed Forces the port to grant access to
•
all clients, either dot1x-aware or otherwise. (This is the
default setting.)
Force-Unauthorzed Forces the port to deny access
•
to all clients, either dot1x-aware or otherwise.
Port State Displays the state of the 802.1X for each port.
Re-authentcate It will trigger the switch to ask a
connected client to restart authentication process.
Force Rentalze It will trigger the specific port of the
switch to restart 802.1X process.
Statstcs The Switch can display statistics for 802.1X
protocol exchanges for any port.
Click Save Settngs to save any changes.
Security > 802.1X Parameter
When 802.1X is enabled, you need to configure the
parameters for the authentication process that runs
between the client and the Switch. The client identity
lookup process that runs between the Switch and
authentication server also needs to be configured. These
parameters are described in this section.
Security > 802.1X Parameter
Enable Reauthentcaton Enables re-authentication.
Reauthtentcaton Perod
the time period after which a connected client must be
re-authenticated. The default value is 600 seconds.
5-Port and 8-Port 10/100/1000 Ggabt Smart Swtches wth PD and AC Power
(1-600 seconds) Sets
Advanced Configuration
EAP Tmeout (1-55 seconds)
during an authentication session that the Switch waits
before retransmitting an EAP packet. The default value is
0 seconds.
Click Save Settngs to save any changes.
Security > Static MAC Address
Static MAC Address allows you to configure a switch port
with the MAC address of one or more devices that are
authorized to access the network through that port. The
MAC address is bound to the ingress port specified on the
list and does not allow the MAC address to change ports.
Only incoming traffic with source addresses already stored
in the static address table will be accepted as authorized
to access the network through that port. MAC addresses
on the list do not age out.
Security > Static MAC Address
MAC Address Enter the specific MAC address for the
system to store and decide the destination port to
forward.
VLAN ID Enter the VLAN ID associated with the specific
MAC address.
Port Select the port associated with the specific MAC
address.
Click Save Settngs to save any changes.
Security > Management Access List
Management Access List specifies which Source IP
addresses can manage the device.
Security > Management Access List
Enable Management Access Lst
Sets the time period
Enable IP Access List.
9