Sanyo PDG-DHT100L Service Manual page 146

Control Port Functions
IC Pin No. Pin Name
H16 29
J16 30
N15 31
U11 32
U12 33
IC5201
V14 35
V15 36
V16 37
V17 38
T17 39
AA19 0
AA18 1
T16 2
W17 3
T15 4
V15 5
Y17 8
W8 9
Y10 10
K18 11
M19 12
W20 13
U20 14
P20 15
N19 16
N18 17
T18 18
T17 19
IC4401 R17 20
R16 21
U21 22
V21 23
W10 24
U10 25
V14 26
U14 28
U11 29
U12 30
V13 31
V10 32
V11 33
U9 34
V9 35
V8 36
V12 37
W7 38
V5 39
FunctionName Function
W_R/C_SW Wired RC Detection
S_SW Not used
IN0_VDET Not used
CS_CTL DVI Equalizer
SIRST HDMI Reset
R2HPDOUT_FPGA Not used
R1HPDOUT_FPGA Not used
FP_EXP_CON Long Cable
PC1/PC2_SW PC1/PC2 Switch
SCART_SW SCART Switch
LENS_SENSE_U Lens Shft Up End Detection
LENS_SENSE_D Lens Shift Down End Detection
LENS_SENSE_R Lens Shift Right End Detection
LENS_SENSE_L Lens Shift Left End Detection
LENS_SENSE_UDC Lens Shift V Center Detection
LENS_SENSE_LRC Lens Shift H Center Detection
FILTER_COUNT Filter Counter Detection
F_MOTOR_SW FilterMotor Enable
FILTER_DET Filter Detection
LAMPCONTROL Lamp Control Detection
LENS_DET Lens Detection
THERM_DETECT Theremistor Detection
- Not used
- Not used
- Not used
- Not used
- Not used
- Not used
- Not used
- Not used
- Not used
- Not used
BALLAST_AC2 Ballast Power On/Off
BALLAST_AC1 Ballast Power On/Off
- Not used
BOOT_HOLD Writing Mode for Formatter Board
M_ASIC_READY DDP ASIC Startup Check
SCL_NIOS Not used
SDA_NIOS Not used
- Not used
- Not used
WP_CW1 CW ID Write Protect Mode Switch
WP_CW2 CW ID Write Protect Mode Switch
LAMP_STAT Lamp Status
INT Not used
PJ_MTR Not used
LENS_TEST Lens ID Write Protect
I/O Operation
I H: Normal, L: Error
I
I
O active:H
O active:L
O
O
O active:H
O H:PC2、L:PC1
O H:SCART L: Other
I H: Top End, L: Other
I H: Bottom End, L: Other
I H: Right End, L: Other
I H: Left End, L: Other
I H: Oner, L: Center
I H: Other, L: Center
I H: Other, L: Count
O H: Stop, L: Operate
I H: Mounted, L: Unmounted
I Lamp On: Pulse 50:50, L: Lamp Off
I H: Detected L: Not Detected
I H: Detected L: Not Detected
-
-
-
-
-
-
-
-
-
-
O H: On, L: Off
O H: On, L: Off
-
O H: Normal, L: Write mode
I H:ASIC Not Start L:ASIC Start
I/O
I/O
-
-
O H: Released L: Protected
O H: Released L: Protected
O H: Other, L: On
-
-
O H: Released L: Protected
-146-