Sanyo PDG-DHT100L Service Manual page 141

Troubleshooting
The projector is detecting abnormal condition.
Indicators
WARNING
POWER LAMP
TEMP.
green red
red
Fig.2 F ilter replacement icon
Fig.3
Fig.4 F ilter cartridge replacement icon
✽ ✽
✽
WARNING LAMP 1/
SHUTTER
FILTER REP.
blue
orange orange
✽
✽
✽
✽
✽
✽
✽
✽
✽ ✽
✽
✽
✽
✽
Projector Condition
If the Filter counter reached a time set in the timer
setting, a Filter replacement icon (Fig.) appears on
the screen and the WARNING FILTER indicator on
the top panel lights up. Replace the filter as soon as
possible. If the filter is out of scroll and the projector
reaches a time set in the timer setting, Fig. 3 appears
on the screen and the WARNING FILTER indicator
lights up. Replace the filter cartridge as soon as pos-
sible.
If the filter is clogged and no scroll is left in the filter
cartridge, a Filter cartridge replacement icon (Fig.4)
appears on the screen and the WARNING FILTER
indicator lights up. Replace the filter cartridge as
soon as possible.
✔ Note:
• Fig., Fig.3 and Fig.4 icon will not appear when the
Display function is set to "Off", or during "Freeze".
The projector detects an abnormal condition during
filter scroll.
The projector is being cooled down after detecting
an abnormal condition during filter scroll.
The projector has been cooled down enough and is
in the stand-by mode
condition during filter scroll.
The filter cartridge is not installed in the projector.
Check the filter compartment to see if the filter car-
tridge is installed in the projector. When the filter car-
tridge is installed and the indicators continue to light
and blink, read the column below.
The projector detects an abnormal condition and
cannot be turned on. Unplug the AC power cord and
plug it again to turn on the projector. If the projector
is turned off again, unplug the AC power cord and
contact the dealer or the service center. Do not leave
the projector on. It may cause an electric shock or a
fire hazard.
The shutter is out of control.
The shutter is out of control. (The projector is in the
cooling mode.)
The shutter is out of control. (The projector is in the
stand-by mode.) In that case, contact the service sta-
tion immediately.
-141-
after detecting an abnormal