The Administration Tab - Factory Defaults; The Administration Tab - Firmware Upgrade; Figure 5-35: Administration Tab - Factory Defaults; Figure 5-36: Administration Tab - Firmware Upgrade - Linksys WRT54GX User Manual

2.4ghz wireless-g broadband router with srx

Hide thumbs Also See for WRT54GX:

Table of Contents

Wireless-G Broadband Router with SRX

Traceroute Test. To test the performance of a connect, enter the address of the PC whose connection you wish

to test and click the Start Test button. The test field will show if the test was successful. To stop the test, click

the Abort Test button. Click the Clear button to clear the screen.

Change these settings as described here and click the Save Settings button to apply your changes or Cancel

Changes to cancel your changes.

The Administration Tab - Factory Defaults

Click the Yes button to reset all configuration settings to their default values, and then click the Save Settings

button. Any settings you have saved will be lost when the default settings are restored. This feature is disabled

by default.

Firmware can be upgraded by clicking the Upgrade button after browsing for the firmware, which you can

download from the Linksys website. Do not upgrade your firmware unless you are experiencing problems with

the Router. For more information about upgrading firmware, refer to "Appendix C: Upgrading Firmware".

Chapter 5: Configuring the Wireless-G Broadband Router

The Administration Tab - Factory Defaults

firmware: the programming code that runs a networking device

download: to receive a file transmitted over a network

Table of Contents