3Com WL-603 User Manual page 125

Figure 100 Add new PPTP VPN Tunnel Screen
1 Set the Tunnel Type to PPTP.
2 Enter a descriptive name for the tunnel in the Tunnel Name field.
3 Enter the User name and Password.
4 Enter the Idle Timeout value.
5 Set the PPTP Type Setting to PPTP Server, or PPTP Client.
if you set the type as PPTP Client, then set the Local Type Setting to
■
Network or Host, then enter the Remote Server IP. Check the Auto
reconnect box, if you want to auto-reconnect after disconnection.
if the PPTP Type Setting is set to PPTP Server, go to step 6.
■
6 Check the box to enable the Remote Network Setting, and then enter the
Remote Network Address, and Remote Subnet Mask information.
7 When the PPTP Type Setting is set to PPTP Client, you would then need to
enter the Pre-shared Key information.
8 Click Apply.
VPN 123