Linksys WET54GS5 User Manual page 51

Wireless-G Ethernet Bridge with 5-Port Switch
Can I run an application from a remote computer over the wireless network?
This will depend on whether or not the application is designed to be used over a network. Consult the
application's user guide to determine if it supports operation over a network.
Can I play multiplayer games with other users of the wireless network?
Yes, as long as the game supports multiple players over a LAN. Refer to the game's user guide for more
information.
What is ad-hoc mode?
When a wireless network is set to ad-hoc mode, the wireless-equipped computers are configured to
communicate directly with each other. The ad-hoc wireless network will not communicate with any wired
network.
What is infrastructure mode?
When a wireless network is set to infrastructure mode, the wireless network is configured to communicate with
a wired network through a wireless access point.
What is roaming?
Roaming is the ability of a portable computer user to communicate continuously while moving freely throughout
an area greater than that covered by a single wireless network access point. Before using the roaming function,
the workstation must make sure that it is the same channel number as the wireless network access point of the
dedicated coverage area.
To achieve true seamless connectivity, the wireless LAN must incorporate a number of different functions. Each
node and wireless network access point, for example, must always acknowledge receipt of each message. Each
node must maintain contact with the wireless network even when not actually transmitting data. Achieving these
functions simultaneously requires a dynamic RF networking technology that links wireless network access points
and nodes. In such a system, the user's end node undertakes a search for the best possible access to the system.
First, it evaluates such factors as signal strength and quality, as well as the message load currently being carried
by each wireless network access point and the distance of each wireless network access point to the wired
backbone. Based on that information, the node next selects the right wireless network access point and registers
its address. Communications between end node and host computer can then be transmitted up and down the
backbone.
As the user moves on, the end node's RF transmitter regularly checks the system to determine whether it is in
touch with the original wireless network access point or whether it should seek a new one. When a node no
longer receives acknowledgment from its original wireless network access point, it undertakes a new search.
Upon finding a new wireless network access point, it then re-registers, and the communication process
continues.
Appendix A: Troubleshooting 45
Frequently Asked Questions