Figure 7-7: Wireless Bridge Diagram - Linksys WAP54G User Manual

Wireless-G Access Point
Wireless Bridge. This mode connects two physically separated wired networks using two access points (use
additional access points to connect more wired networks). This feature only works with another Wireless-G
Access Point (model number: WAP54G).
To configure a Wireless Bridge environment, select Wireless Bridge, and enter the MAC addresses of the
wireless bridges/access points in the Remote Wireless Bridge's LAN MAC Addresses fields. You will also need to
set the remote wireless bridges/access points to Wireless Bridge mode.
Change these settings as described here and click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Click Help for more information.
Chapter 7: Configuring the Wireless-G Access Point
The Setup - AP Mode Tab

Figure 7-7: Wireless Bridge Diagram

IMPORTANT: In Wireless Bridge mode, the Access
Point can ONLY be accessed by another access point
in Wireless Bridge mode. In order for your other
wireless devices to access the Access Point, you
must reset it to Access Point mode. The two modes
are mutually exclusive.
42