Baud Rate - Sony DXC-390P Instructions For Use Manual

Setting item Contents of
setting
(HD/VD lock) Adjusts the
H. PHASE* horizontal phase
during external
synchronization
(with HD/VD
signal input).
* Displayed only when an external sync signal is input.

BAUD RATE

Switches the baud rate of the REMOTE
connector at the rear panel.
Sets to any of 19200, 9600, 4800, 2400 and
1200.
Normally, set to 9600 when the RM-C950
remote control unit is connected to the
REMOTE connector.
Note
When the CMA-D3CE
camera using the CCMC-3MZ
cable, "CMA-D3" will appear and you
cannot select the baud rate.
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
D-SUB VIDEO
Switches the video signal output from the
RGB/SYNC connector (D-sub 9-pin)
at the rear panel.
VBS
Outputs VBS signal.
Y/C
Outputs Y/C signal.
Note
When the CMA-D3CE
camera with the CCMC-3MZ
cable, the item does not function.
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
Ref.
page
28
*
is connected to the
*
connecting
*
is connected to the
*
connecting
D-SUB SYNC
Switches the sync signal output from the
RGB/SYNC connector (D-sub 9-pin)
at the rear panel.
C.SYNC
Outputs the composite sync signal.
WEN
Outputs the WEN signal. When connecting
peripheral equipment, the signal is used as
trigger pulse output to the equipment.
Select the polarity of the WEN signal with
the POLARITY setting.
: Negative
: Positive
Note
When the CMA-D3CE
camera with the CCMC-3MZ
cable, this item is fixed to WEN.
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
RGB SYNC
Adds a sync signal to the G signal or R, G
and B signals output from the
SYNC connector.
OFF
No sync signal is added to an output signal.
G
Adds a sync signal to the G signal output
from the RGB/SYNC connector.
RGB
Adds sync signals added to the G, B and R
signals output from the
connector.
*
is connected to the
*
connecting
RGB/
RGB/SYNC
27
SYSTEM menu