Sony DXC-390P Instructions For Use Manual page 28

12P CONNECTOR
Switches the input and output of the
IN/VBS connector (12-pin). Selects the
output signal from this connector when OUT
is selected.
IN
Functions as the input connector.
OUT
Functions as the output connector.
Select the output signal with the SIGNAL
setting.
HD/VD: Outputs the HD/VD signal.
C. SYNC: Outputs the composite sync
signal.
Note
When the CMA-D3CE
camera with the CCMC-3MZ
cable, you cannot set this item. Switch
between input and output with the IN/OUT
switch on the CMA-D3CE
For details, refer to the operating
instructions of the CMA-D3CE
* CMA-D3CE/CCMC-3MZ are intended for general
purpose use. They are not intended for medical use.
VBS lock
Appears only when an external reference
sync signal (VBS signal) is input. Adjusts
the horizontal phase and SC (subcarrier)
phase to synchronize the camera operation
with the reference signal.
H.PHASE
Adjusts the horizontal phase within the
range from –20 to +127.
SC.PHASE ROUGH
Roughly adjusts the subcarrier phase by
setting to 0° or 180°.
28
SYSTEM menu
DC
*
is connected to the
*
connecting
*
camera adaptor.
*
.
SC.PHASE FINE
Finely adjusts the subcarrier phase within
the range from –127 to +127.
HD/VD lock
Appears only when an external reference
sync signal (HD/VD signal) is input. Adjusts
the horizontal phase to synchronize the
camera operation with the reference signal.
Select H.PHASE, then adjust the level
within the range from –20 to +127.