Replacing One Type Of Exhaust Filter With Another; Maintenance Indicator With Reset Button; Inserting Batteries Into The Led Handle); When To Change The Thread Lifters - Miele HS15 Operating Instructions Manual

Replacing one type of exhaust filter
with another
Do not use more than one exhaust
filter at a time.
You can replace the standard HEPA
AirClean 50 filter c with either one of the
following exhaust filters:
a Air Clean
b ActiveAirClean 50.
When replacing the HEPA AirClean
50 filter with an Air Clean filter, plea-
se note (dia. 34)
If you wish to replace the HEPA AirCle-
an 50 filter c with an Air Clean filter a,
then it is essential that you also fit the
filter grille (See "Optional accessories").
Maintenance indicator with reset
button (dia. 35)
The indicator lights up after approx.
50 hours of operation, which is
equivalent to about a year of average
use. The level of soiling of the dust
compartment filter and the exhaust filter
must be checked at this point and if the
filters are replaced, the indicator must
be reset. To do this the vacuum cleaner
must be switched on.
^ Press the reset button.
The maintenance indicator and reset
button will go out and reset to zero.
The indicator can only be reset by
pressing the reset button after the
light has come on. Pressing the
button at any other time will have no
effect.
Inserting batteries into the LED
handle (dia. 9 + 10)
You will need three 1.5 V (AAA) batteries.
a Loosen the screws on the cover.
b Press down on both sides of the
cover to remove.
c Take out the battery holder and
change the three batteries, making
sure they are the right way round.
d Replace the battery holder. in the
direction of the arrows on the holder
and battery compartment, so that
both line up.
e Replace the cover and tighten the
screws.

When to change the thread lifters

The thread lifters on the suction inlet of
the floorhead can be replaced.
Check them from time to time and re-
place them if the pile has worn down.

How to replace the thread lifters

AllTeQ floorhead (dia. 36)
^ Use a suitable screwdriver to remove
the thread lifters from the slots. There
are two grooves to help you.
^ Fit new thread lifters.
AirTeQ floorhead (dia. 37)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
en
41