Replacing One Type Of Exhaust Filter With Another; Replacing The Thread Lifters; Cleaning And Care - Miele Complete C2 Tango Operating Instructions Manual

Replacing one type of exhaust filter
with another (Fig. 09)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Active AirClean 50 (black)
d HEPA AirClean 50 (white)
Do not use more than one exhaust
filter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
If you are using exhaust filter c or d,
you must also activate the timestrip®
filter change indicator (Fig. 12).
2. If you wish to replace exhaust filter b,
c or d with filter a it is essential that
filter a is fitted in the filter grille* (Fig.
34).
* Filter grille – see "Optional ac-
cessories"

Replacing the thread lifters

(Fig. 37 + 38)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care


Risk of electric shock from mains
voltage.
The mains voltage is applied to the
appliance even if it is switched off.
Before cleaning, switch the appli-
ance off at the wall socket and un-
plug it.
Vacuum cleaner and accessories

Risk of electric shock from mains
voltage.
If moisture gets into the vacuum
cleaner, there is a risk of electric
shock.
Do not let the vacuum cleaner get
wet.
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.
en
43