Replacing One Type Of Exhaust Filter With Another; Replacing The Thread Lifters - Miele COMPACT C2 FLEX Operating Instructions Manual

 Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position.
 If you are using exhaust filter c, d or
e, you must also activate the
timestrip® filter change indicator.
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display.
If you wish to fit an AirClean exhaust
filter, see "Replacing one type of ex-
haust filter with another".

Damage due to contamination in
the dust compartment
Large quantities of dust may enter
the dust compartment and damage
components if the dustbag has not
clicked into position.
Before closing the dust compartment
lid, make sure that the dustbag has
been inserted so that it has clicked
into position.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
Replacing one type of exhaust filter
with another (Fig. 06)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Silence AirClean 50 (grey)
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
Do not use more than one exhaust
filter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c, d or e, it is essential
that you remove the filter grille before
you fit the new exhaust filter.
If you are using exhaust filter c, d or
e, you must also activate the
timestrip® filter change indicator
(Fig. 09).
2. If you wish to replace exhaust filter b,
c, d or e with filter a, it is essential
that you also fit the filter grille* (Fig.
32).
* Filter grille – see "Optional ac-
cessories"

Replacing the thread lifters

(Fig. 35 + 36)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.
en
47