Additional 2-Way Lcd Remote Control Functions - Code Alarm ca5554 Owner's Manual

Additional 2-Way LCD Remote Control Functions

Check Vehicle Status
Press and release
display the current status of the vehicle.
Display Illumination
Press and hold the
Melody / Vibration Mode
To have the remote control vibrate, play a melody tone or both each time it receives a
response from the vehicle press and release
seconds.
Button Beeps
To toggle button beeps on or off press and release
seconds.
Battery Save Mode
While in POWER SAVE MODE the 2-way LCD transmitter will NOT look for any
incoming signals from the main unit until a button is pressed. The LCD screen will
display SAVE to indicate that power save mode is ON. To enter power save mode
press and hold
Clear Flashing Icons and Melody Sound
Press the button 3 times within 3 seconds. This will clear the melody sound and
flashing icons on the LCD screen.
Button Lock
Press and release
on or off. When the button lock is active, the remote control will beep/vibrate 2 times
when a button is pressed indicating it is locked.
Illumination
Press and release
illumination on or off. When on, the display will illuminate when it receives or sends a
command.
2014 Voxx Electronics Corporation. All rights reserved.
2 times then press
button for 1 second. The display will illuminate for 5 seconds.
for 5 seconds.
then press hold the
2 times then press and hold
within 3 seconds, the transmitter will
then press and hold
then press and hold
for 2 seconds to toggle the button lock
for 2 seconds to toggle
for 2
for 2
9