Edimax NS-2501 Quick Installation Manual page 10

ON
Off
USB1
Slow
Flashing
Fast
Flashing
ON
Off
USB2
Slow
Flashing
Fast
Flashing
ON
Off
HDD
Slow
Flashing
Fast
Flashing
USB storage device is connected to USB1 port
USB storage device is not connected to USB1 port
or is not detected due to hard disk failure or the
system is doing partition/format on this hard disk
drive.
The used space of the USB mass storage is over
95% or the USB Copy tool is copying from the USB
mass storage device plugged to USB1 port.
The USB mass storage is full or the USB Copy tool
is copying from the USB mass storage device
plugged to USB1 port, but this job faces some error
and is stopped (In this situation, the LED will keep
flashing about 30 seconds and go off).
USB storage device is connected to USB2 port
USB storage device is not connected to USB2 port
or is not detected due to hard disk failure or the
system is doing partition/format on this hard disk
drive.
The used space of the USB mass storage is over
95% or the USB Copy tool is copying from the USB
mass storage device plugged to USB2 port.
The USB mass storage is full or the USB Copy tool
is copying from the USB mass storage device
plugged to USB2 port, but this job faces some error
and is stopped (In this situation, the LED will keep
flashing about 30 seconds and go off).
Internal SATA hard disk drive is installed
Internal SATA hard disk drive is not installed or is not
detected due to hard disk failure or the system is
doing partition/format on this hard disk drive.
The used space of the internal SATA hard disk drive
is over 95%.
The internal SATA hard disk drive is full.
9