Advertisement
Remove screws, retain gaskets
Figure 1 - ATM Camera with Plastic/Metal Bracket
Installing Camera Using the Plastic/Metal Bracket:
4. Remove the center screw to separate the metal
bracket from the plastic one.
5. Figure 2 shows the parts referenced in this
section.
6. Use the camera's metal bracket as a template
to mark the hole pattern in the mounting
surface.
7. Attach the metal bracket to the mounting
surface using the three #4-40 screws included in
the hardware kit, or other appropriate
customer-supplied fasteners.
8. To attach the plastic bracket to the metal
bracket, place the center screw through the
center hole in the plastic bracket, with the
nylon washer under the head of the screw.
9. On the opposite side, place the gasket over the
threads of the screw. The gasket should hold
the screw/washer in place.
10. Align the center screw with the hole in the
metal bracket and tighten the screw.
Figure 2 - Disassembled Camera Bracket
11. Orient the camera with the "Pixim" logo facing
down (towards the ground). This will ensure the
image is not upside down on screen.
12. Reattach the camera to the plastic bracket using the
two screws and gaskets.
13. Run power and coax to the site. Terminate the coax
cable with a BNC plug.
14. Provide strain relief for the power connection, if
needed.
15. Supply power to the camera.
16. Use a test monitor to ensure the camera is in focus
and pointing in the desired direction.
17. If the camera is out of focus, loosen the nut
surrounding the lens, twist the lens right or left until
the image is in focus, then tighten the nut to secure
the lens in place.
Metal Bracket
#4-40 Screws
Nylon Washer
Center Screw
Camera
Gasket
Plastic Bracket
Side screws with
gaskets (2 per)
Zip Tie
4
Advertisement
