Advertisement
Unpacking
Unpack carefully. This is electromechanical equipment
and should be handled with care. If an item appears to
have been damaged in shipment, replace it properly in
its carton and notify the shipper. If any items are
missing, notify Linear LLC. The shipping carton is the
safest container in which the unit may be transported.
Save it for possible future use.
Service
If the unit ever needs repair service, the customer
should contact Linear LLC for a return product
authorization (RPA) and shipping instructions.
Care and Maintenance
Clean the lens as needed with a soft cloth or Kimtech™
Kim Wipe delicate task wipes. Use a mild detergent
solution or water.
Model Designation
CAM690ATM
ATM Camera, 690TVL, Pixim
Seawolf, 3.6mm lens, generic
mounting bracket, 12VDC
CAM690ATM-28
ATM Camera, 690TVL, Pixim
Seawolf, 2.8mm lens, generic
mounting bracket, 12VDC
ATM58KTS
ATM Camera Kit, 690TVL, Pixim
Seawolf, 2.8mm lens, mount
bracket for NCR™ 5800 Series
ATM's, 12VDC
Description
The ATM Camera series features Pixim™ DPS imaging
technology in a compact design. A wide angle lens is
used with an adjustable mounting bracket to provide a
wide range of installation options. A mounting bracket
specific to certain NCR™ ATM's is included with the
camera in model # ATM58KTS.
Installation Note
Installation of this device should be performed by a
licensed professional where required and should
conform to the National Electrical Code (NEC) and all
applicable local codes.
Hardware Kit
CAM690ATM-xx
1 x Cable Tie
1 x ¼-20 Thumb Screw
1 x ¼" Fender Washer
1 x ATM Bracket
1 x Camera Bracket
1 x #10-32 x 3/8" Screw
1 x #10 Washer
1 x Power Adapter
3 x #4-40 Screws
ATMN58KTS
1 x Cable Tie
1 x ¼-20 Thumb Screw
1 x ¼" Fender Washer
1 x Bracket
1 x Power Adapter
Installation – ATM58KTS
1. This unit ships pre-assembled, ready to install in an
ATM.
2. Refer to installation manual 100 0234 001 AIG for
instructions on installing this camera in a NCR 5800
Series ATM's.
3. Skip to Appendix A for information on camera
settings.
Installation – CAM690ATM-xx
This camera ships with a pre-installed plastic & metal
base for wall or ceiling- mount installations. If installing
the unit in an ATM, remove the base and attach the
generic ATM bracket.
1. Remove the two screws in the bracket arms (see
Figure 1). Two gaskets surround each screw. Do
not discard these gaskets.
2. If installing the unit using the plastic/metal bracket,
continue to the next section.
3. If installing the unit using the generic metal ATM
bracket, skip to the section titled "Installing Camera
Using ATM Bracket".
3
Advertisement
