Installation; Installing The Base Stand; Mounting On The Wall - Technika 42-502 Owner's Manual

INSTALLING THE BASE STAND

WARNING: The display is very fragile, and must be protected at all times when installing the base stand. Be sure
that no hard or sharp objects, or anything that could scratch or damage the display come in contact with it. Do
NOT place pressure on the rear of the unit at anytime because the screen could crack.
1. Disconnect any cables or cords connected to the unit.
2. Lay the unit down on a flat surface, so the back side is facing up, making sure to place a soft cushioned
material (such as a blanket or thick piece of foam) beneath the screen.
3. Put the stand into the hole at the bottom of the TV.
4. Insert screw into the hole and tighten.

MOUNTING ON THE WALL

This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 15 3/4" x 7 7/8" (400mm
x 200mm) mounting kit designed for flat-panel TVs (sold separately). Mount this unit according to the directions
included with the mounting kit.
NOTE:
Remove the base stand before mounting the unit on the wall.

INSTALLATION

E-3