Installation; Removing The Base Stand; Mounting On The Wall - Technika LCD17DVDID-108 Owner's Manual

inStaLLation

REMOVING THE BASE STAND

WARNING: The LCD Display is very fragile, and must be protected at all times when removing
the base stand. Be sure that no hard or sharp object, or anything that could scratch or damage the
LCD display, comes into contact with it. Do NOT place pressure on the front of the unit at any time
because the screen could crack.
1. Disconnect any cables or cords connected to the unit.
2. Lay the unit down on a flat surface, so the back side is facing up, making sure to place a soft
cushioned material (such as a pillow or thick piece of foam) beneath the screen.
3. Remove the four screws and then remove the BASE STAND from the TV.

MOUNTING ON THE WALL

This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 100mm x
100mm mounting kit designed for flat-panel TVs (sold separately). Mount this unit according to the
directions included with the mounting kit.
Note: Remove the base stand before mounting the unit on the wall.
100mm
Four
mounting
holes
Size: M4 screws
6
PLV31170S1E4 IB CI DTV 080131.indd 6 2/1/2008 3:16:26 PM