Inset live fuel effect gas fire
incorporating the baxi fires division control
fitted with one of the following fascia.
adorn, decadent, dream,
eternal, icon, obsession or
visage (47 pages)
Page 3
BS EN ISO 9001 quality system accepted by the British Standards Institute. The Highest Standards Baxi Fires Division is a member of the Society of British Gas Industries which works to ensure high standards of safety, quality and performance. Careful Installation Baxi Fires Division is a CORGI registered company.
OWNER GUIDE LIST OF CONTENTS Section Page SAFETY APPLIANCE DIMENSIONS GAS CONSUMPTION OPERATING YOUR FIRE The Oxysafe flame sensing and flue blockage safety system. To light the fire (Manual ignition). To light the fire (Electronic ignition). CLEANING YOUR FIRE REPLACING THE RADIANTS MAINTENANCE Battery replacement (Electronic ignition).
Page 5
OWNER GUIDE Do have the chimney swept prior to installation if it was previously used for solid fuel. Do have the fire installed in accordance with the installation instructions Do allow a minimum clearance of 90mm from the top of the appliance fascia to the underside of any shelf whether it is made from combustible or non-combustible materials.
OWNER GUIDE altering the room. Don’t hang clothing, towels or any other fabrics over the fire. Don’t fill in the space behind the fascia. Don’t use the fire without the dress guard being in position. Don’t attempt to clean or service the fire until it has been switched off and allowed to cool completely.
OWNER GUIDE OPERATING YOUR FIRE PLEASE NOTE When operating your fire for the first time, some vapours may be given off which may cause a slight odour and could possibly set off any smoke alarms in the immediate vicinity. These vapours are quite normal with new appliances. They are totally harmless and will disappear after a few hours use.
OWNER GUIDE The control knob can then be set to your preferred heat level. The settings are shown in the table below: Control Knob Radiants Condition Position Centre radiants on low. Outer radiants off. (The right hand centre radiant will glow slightly more than than the left hand centre radiant due to the pilot flame) Centre radiants fully on.
REPLACING THE RADIANTS See figure 4. Always use the correct type of replacement radiant. Ask for Baxi Fires Division part number 5110472 Turn the fire off and allow it to cool before attempting to remove the radiants. Remove the dress guard by pressing down the two hooks at the top.
If you wish to replace the radiants, spare parts are available nationwide via the ‘interpart stockist network’. For your local stockist consult Yellow pages under Central Heating. When fitting replacement parts it is important that only Baxi Fires Division approved parts are used for maximum safety. USEFUL TELEPHONE NUMBERS...
Need help?
Do you have a question about the 347 and is the answer not in the manual?
Questions and answers