Network Component Configuration - Linksys USB100TX User Manual

5. Windows will finish installing the software onto your PC. Click Finish.
6. When asked if you want to restart your PC, remove the Driver Disk and
click Yes.
The Windows Millennium driver installation is complete. Please continue
on to the next section, which will provide instructions for configuring
Windows Millennium's network protocol. Check with other networked
computers for your network configuration information if necessary.
21
Linksys EtherFast ® Series 10/100 USB Network Adapter

Network Component Configuration

1. Once you are back at the Windows Millennium desktop, click on your
taskbar's Start button, then Settings, then Control Panel, then double-
click the Network icon.
2. The Network window will appear. Click on the Configuration tab. A
window similar to the one below will appear. There may be other compo-
nents listed in addition to the ones shown below (for example, a Dial-up
Adapter), which is normal. You will need to manually install one of the
protocols listed below. It is recommended that you install TCP/IP and pro-
vide an IP addresss to use the Internet services. If you are not sure what
protocol you need, you can just install IPX/SPX and NetBEUI protocols
for your local area network.
• Client for Microsoft Networks
• Linksys EtherFast 10/100 USB Network Adapter
• TCP/IP
If any of the components shown above are missing, however, you'll need
to manually install them. If so, refer to Manually Installing Network
Components now.
N N o o t t e e : : Linksys
does not pro-
vide technical
support for
TCP/IP config-
uration or troubleshooting.
22