Assembly Instructions - George Foreman BRAIN STORM TURBO GFSB1 Owner's Manual

CAUTION: Use extreme care when handling the Blade
Assembly. Do not touch the Blades with your fingers. The
Blades are very sharp and can cause injury if touched.
1. Turn the Blender Container
upside down. Place the
Rubber Seal Ring over the
opening on the bottom of
the Blender Container.
2. Carefully insert the Blade
Assembly into the opening at
the bottom of the Container.
3. Place the Collar over the
Blade Assembly and turn the
Collar clockwise to engage
the threads. To securely
tighten, continue turning until
the indentations in the Collar
align with the indentations in
the Blender Container.
NOTE: The Blade Assembly
must be firmly attached to
the Blender Container before
use.
4. Place the Rubber Pad on
top of the Motor Housing.
Make sure that the center
opening of the Rubber Pad
is seated beneath the Blade
Assembly drive gear.
NOTE: The Rubber Pad
must be properly in place
before operating the
Blender.

Assembly Instructions

Drive
Gear
BRAIN
7
Collar
Blade
Assembly
Rubber
Seal
Ring
Blender
Container
Rubber
Pad
STORM ™