Table of Contents
Advertisement
10
www.aeg.com
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
the display is blank.
2. Press Program.
• The indicators
go off.
• The indicator
flash.
• The display shows the current
setting: e.g.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
the display is blank.
2. Press Delay.
• The indicators
and
start to flash and
and
continues to
= level 5.
and
start to flash and
and
go off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
,
3. Press Delay again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.4 Use of rinse aid and multi-
tablets
When you activate the option Multitab,
the rinse aid dispenser continues to
release rinse aid. However you can
deactivate the rinse aid dispenser. In this
case the drying results may not be
satisfactory.
With the rinse aid dispenser deactivated,
the rinse aid indicator is always off.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
the display is blank.
2. Press Start.
• The indicators
off.
• The indicator
continues to flash.
• The display shows the current
setting:
,
activated.
3. Press Start to change the setting.
= rinse aid dispenser
deactivated.
The rinse aid indicator goes off.
4. Press the on/off button to confirm
the setting.
continues to
= level 4.
and
start to flash and
and
= rinse aid dispenser
,
go
Advertisement
Table of Contents
