Installation - Pioneer DEH-X9650SD Owner's Manual

Installation

This unit
6
1 2 3 4 5 7 8
b a 9
c
1 Antenna input 15 cm
2 Fuse (10 A)
3 Power cord input
4 Wired remote input
Hard-wired remote control adapter can be
connected (sold separately).
5 Microphone input (DEH-X9650BT and DEH-
X8650BT only)
6 Microphone (DEH-X9650BT and DEH-
X8650BT only)
4 m
7 Rear output
8 Front output
9 Subwoofer output
a USB port 2 (DEH-X9650BT and DEH-X9650SD
only)
b USB port 1
c USB cable 1.5 m
Power cord
Perform these connections when not connect-
ing a rear speaker lead to a subwoofer.
1
L R
2 3
 
4
6 8
F
7 9
 
 
5
c
R b d


e
f
g
h
i
Perform these connections when using a sub-
woofer without the optional amplifier.
1
L R
2 3
 
4
6 8
F
7 9
 


j
c
b d
SW


e k

c
f
g
l m
h
b
d
i 
1 To power cord input
2 Left
3 Right
4 Front speaker
5 Rear speaker
6 White
7 White/black
8 Gray
Installation
9 Gray/black
a Green
b Green/black
c Violet
d Violet/black
e Black (chassis ground)
Connect to a clean, paint-free metal location.
f Yellow
Connect to the constant 12 V supply termi-
nal.
g Red
Connect to terminal controlled by ignition
switch (12 V DC).
h Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control ter-
minal (max. 300 mA 12 V DC).
i Orange/white
Connect to lighting switch terminal.
j Subwoofer (4 W)
k When using a subwoofer of 70 W (2 W), be
sure to connect the subwoofer to the violet
and violet/black leads of this unit. Do not
connect anything to the green and green/
black leads.
l Not used.
m Subwoofer (4 W) × 2
Notes
! When using a two-speaker system, do not
connect anything to speaker leads that are
not connected to a speaker.
! Change the set up menu of this unit. Refer to
S/W control (rear output and subwoofer set-
ting) on page 17.
The subwoofer output of this unit is monau-
ral.
Power amp (sold separately)
Perform these connections when using the op-
tional amplifier.
3
1
2
4
 
5 5
 
3
2
1
6
 
7 7
 
3
2
1
8
 
9 9
 
1 System remote control
Connect to Blue/white cable.
2 Power amp (sold separately)
3 Connect with RCA cables (sold separately)
4 To Rear output
5 Rear speaker
6 To Front output
7 Front speaker
8 To subwoofer output
9 Subwoofer
Installation
Important
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
Section
03
19
En