Indoor Unit Control - Mitsubishi Electric PKH18FK3 Technical & Service Manual

2. INDOOR UNIT CONTROL

2-1 COOL operation
SWING
DRY COOL
TIMER OFF TIMER CLOCK AUTO AUTO
FAN
AUTO
CHECK SET TEMP. START STOP
SPEED
HEAT
MODE TIMER ON/OFF CLOCK/TIMER FAN SPEED AIR DISCHARGE FILTER
SET TEMP. TIMER SET
REMOTE CONTROLLER
<COOL operation time chart>
Thermostat
Indoor fan
Auto vane
Booster heater
Compressor
w1 Even if the room temperature displayed on remote controller rises above the set temperature during this period, the com-
pressor will not start until this period has ended.
<How to operate>
1 Press the ON/OFF button.
2 Press MODE button to set operation mode to Cool.
3 To set desired temperature, press SET TEMP.button.
F
NOTE : Set temperature changes by 2˚F in the range 65~87˚F, each
AUTO
RETURN
AIR SWEEP CHECK
TEST RUN
The room temperature
Operation starts by
displayed
O N / O F F b u t t o n
controller becomes equal
ON.
to set temperature.
ON
OFF
LOW or HIGH
ON
OFF
Initially 10°(Changeable by remote controller setting)
CLOSE
ON
OFF
OFF
ON
OFF
time SET TEMP. button is pressed.
The room temperature
displayed on Remote
on Remote
controller rises above
set temperature.
LOW or HIGH
W
Minimum 3 minutes 1
28
Operation stops by
O N / O F F b u t t o n
OFF.
CLOSE