Makita 2702X1 Instruction Manual page 21

NOTE:
When widths slightly greater than the above are required, fit the paper washers in
between the inside and outside cutters to adjust the width
@
Arrange the cutters so that the tips of
the inside cutters are positioned at the
gullets of the outside cutter.
When more
than
one
inside cutter is
used, space the tips of the inside cutters
equidistantly in relation to one another.
Poorly spaced cutters may cause vibra-
tion and noise.
Outside cutter 7 - -
1 -
Gullet
Inside cutter
When installing two outside cutters
without any inside cutter, be sure that
the cutter tips do not face each other.
0
X
@
While tightening the hex nut, be careful to maintain the even spacing between the tips
@
Rotate the dado head one turn by hand to make sure that
it
does not contact anything
of the inside cutters.
before operation.
When dadoing, use featherboards. The dia-
gram shown illustrates dimensions for mak-
ing a typical featherboard. It should be
made from a straight piece of wood that is
free of knots or cracks.
21