Makita 2702X1 Instruction Manual page 14

Wood facing ( r b fence)
I
A wood facing should be used for opera-
tions when the blade comes close to the
rip fence. Wood facing for the rip fence
should be same size as the rip fence. Make
sure the bottom of facing is flush with the
table surface.
No. 10 wood screws
(long enough t o penetr:
halfway into facing)
Crosscutting
CAUTION:
When making a crosscut, remove the rip fence from the table.
When cutting long or large workpieces, always provide adequate support to the sides of
the table. The support should be at the same height as the table.
Miter gauge
Use the miter gauge for the 4 types of cutting shown below
n i
I
CROSS CUTTING MITERING BEVEL CUTTING COMPOUND MITERING (ANGLES1
CAUTION :
Secure the knob on the miter gauge carefully.
*Avoid creep of workpiece and gauge by firm workholding arrangement, especially when
cutting at an angle.
14