Menu (F) - TAG Heuer HL 440 User Manual

5. Menu (F)

OPEN RUN: start a new timing run after closing the previous run. The run number is displayed when
input 1 is unblocked.
CLOSE RUN: Exit the current run with this option. Times will be saved but cannot be modified later.
SYNCHRO: to establish a new time-of-day synchronization.
•
Manual synchro
•
•
•
Slave synchro
•
Chrono Mode:
PTB Sequential: (1 to 4) or (5 to 8)
Sequential recording of time-of-Day on 4 channels ( 8 channels if 2 HL 440's are connected together
with RS232 connection). This mode does not calculate Net Times!
In this mode, bib number entry is not possible.
SPLIT: (1 to 4) or (5 to 8)
Sequential recording of time-of-Day on 4 channels (8 channels if 2 HL 440's are connected together
with RS232 connection). This mode will not calculate Net Times.
In this mode, it is possible to enter bib numbers.
TRAINING:
This mode allows you to perform automatic timing for Training sessions, with a Start, two intermediates
and a Finish. This mode will automatically recognize the bib numbers after the start at both intermediate
locations and at the finish, through the "Capture windows" information specified in the Parameters
Menu.
IMPORTANT
In the TRAINING MODE, several runs for a competitor can be memorised for later analysis
during a timing session.
RANKING / RANK A
Ranking of the current timing session or any memorized session. Note that only the best time of each
competitor will be displayed on the LCD or printed.
LISTING / LIST A SESSION:
This is a listing of a competitor number's times in chronological order for the current session, or any
memorized session. All the times (Inter 1, 2 and Finish) will be displayed for each run within the session.
# 01 COMPETITOR
INTER 1
INTER 2
FINISH
CLEAR MEMORY: Clear the memory only when you start a new timing session and you are sure you
do not need to retain the previous session(s) in memory!
Enter Synchro Date (dd:mm:yy) and Time (hh:mm), confirm with
Synchro the Minitimer with the Manual Green Key (1 – 4) or if the system should be
synchronized as along with another device from an external input (1 – 4), do not
forget to unblock the associated external input (Red key 1 – 4).
This will put the Minitimer in Slave mode. The Device will wait for the time-of-day
information through the serial Input « Printer » from another Minitimer «master»
SESSION: (only in the Training mode)
(only in the Training mode)
1
10.23
23.56
42.98
Page 11
◄┘