Attaching The Handle - Ellison E2201-18 User Manual

Attaching the Handle

① Once the handle components are fully assembled, the next step is to attach the handle to the mower. Do not install the Grass Bag yet.
② Note the attachment pegs on the inside facing surfaces of the main mower body. Shown in the inset as (I). These are easiest to see
and connect to when the mower's cutting height is set to the 4 in. position.
③ While gripping the handle by the Lower Handle tubes shown as position (J) and (K), squeeze these two areas inward and hook the
holes in the ends of the tubes onto the attachment pegs from the main mower body (I).
④ Stop squeezing inward, and allow the handle assembly to relax.
⑤ If the handle is rotated upward fully, it is in its storage position. When rotated downward, it will stop at its usage position.
⑥ Test the height of the usage position. There are multiple height positions for the Handle. See page 7 for adjustment instructions.
⑦ To remove the handle, squeeze areas (J) and (K) inward and unhook from the attachment pegs (I).
8
Attachment
Peg (I)
(J)
(K)
8