Handle Assembly - Ellison E2201-18 User Manual

Handle Assembly (first time use)
① There are no tools required for assembly of the handle.
② Note that the Upper Handle (A) is already factory pre-assembled with the
Center Handle (B), the Handle Cover (C), and the Handle Bolts (D).
③ Lay out the parts as shown below. Note the Lower Handle parts (E) are
symmetric, and there is no right or left version.
④ In order to install the Lower Handle parts (E) into the Center Handle (B),
you must first remove the Handle Cover (C) by flexing the plastic Snap
Arms (F) outward and pulling the Handle Cover (C) upward. (See inset
image)
⑤ Next, remove the Lower Handle Bolt (D) by loosening the Handle Knob
(G). Be sure to keep the Handle Washer (H).
⑥ Insert the free ends of the Lower Handles (E) into the Center Handle (B),
making sure that they are resting flat on the ground. Align the holes in the
position that is most comfortable for usage.
Center Handle (B)
Upper Handle (A)
7
Note: There are multiple positions for handle height. If uncertain, start in
the lowest handle height position and adjust to a height that is the most
comfortable for you. Both bolts locations can adjust height of handle.
⑦ Insert the Lower Handle Bolt (D) through the Center Handle (B) and
through the Lower Handles (E).
⑧ Once the threaded portion of the Lower Handle Bolt (D) is sticking
through the tubing fully, assemble the Handle Washer (G) and then
screw on the Handle Knob (F).
⑨ Using the knob, tighten the bolt until it is snug. Do not over tighten or
permanent damage to the handle may result.
⑩ Snap the Handle Cover (C) over the Center Handle (B).
Handle Cover (C)
Lower Handle Bolt (D)
Handle Washer (H)
Handle Knob (G)
Snap Arms (F)
Lower Handles (E)
7