Controlling the Camera: PC Mode
In PC mode, a camera equipped with a WT-3 can be controlled over a wireless net-
work from a computer running Nikon Capture 4 version 4.4 or later (available sepa-
rately) and photographs saved directly to the computer hard disk instead of the
camera memory card. The principal steps are:
Connect to the computer ....................................................
Control the camera using Nikon Capture 4 ..................
The WT-3 Setup Utility must be installed on the host computer. Before connecting
to the host, create a host profi le using the WT-3 Setup Utility (
that the host is running.
Connecting to the Computer
1
To access the network via Ethernet, connect the Ethernet cable (
that wireless transfer is disabled while an Ethernet cable is connected. Dis-
connect the Ethernet cable before accessing a wireless network. Turn the
camera off before connecting or disconnecting the Ethernet cable.
2
Turn the camera on.
Choose PTP
Before connecting the WT-3, set the USB option in the camera setup menu to PTP
(
15).
PictureProject Version 1.6.1 or Later
In PC mode, PictureProject Transfer can be used to transfer pictures to the com-
puter, where they will be cataloged in the PictureProject software supplied with the
camera (version 1.6.1 or later required).
37–38
39–41
15–23) and be sure
5). Note
37