Electrolux EWP 107100 W User Manual page 9

35°
• After positioning the inlet hose, be sure to
tighten the ring nut again to prevent
leaks.
WATER DRAINAGE
Form a hook at the end of the drain hose
using the plastic hose guide, if necessary.
The end of the drain hose can be posi-
tioned in four ways:
• Hooked over the edge of a sink using
the plastic hose guide.
Tie the plastic hose guide to the tap with
a string to prevent that the drain hose un-
hooks when the appliance is emptying.
• Onto a sink outlet spigot.
45°
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is
formed in the drain hose to prevent
waste from the sink entering the appli-
ance.
If the outlet spigot has not been used be-
fore, remove any blanking plug that may
be in place.
• Directly into a drain pipe at a height
of not less than 60 cm and not more than
100 cm. The end of the drain hose must
always be ventilated, i.e. the inside di-
ameter of the drain pipe must be larger
than the outside diameter of the drain
hose. The drain hose must not be kinked.
• Directly to a built-in drain pipe in the
room wall.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your Local Centre.
electrolux 9