Folding The Handle; Preparing The Mower For Storage; Removing The Mower From Storage - Lawn-Boy Insight 10780 Operator's Manual

Figure 41
2. When no more clippings come out, stop the water and
move the mower to a dry area.
3. Run the engine for a few minutes to dry the housing
to prevent it from rusting.
Storage
Store the mower in a cool, clean, dry place.
Preparing the Mower for
Storage
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the mower in an enclosure near an
open flame.
•
Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2. Run the mower until the engine stops from running
out of fuel.
3. Prime the engine and start it again.
4. Allow the engine to run until it stops. When you can no
longer start the engine, it is sufficiently dry.
5. Disconnect the wire from the spark plug and connect
the wire onto the retaining post.
6. Remove the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder to
prevent cylinder corrosion during the off-season.
7. Loosely install the spark plug.
8. Tighten all nuts, bolts, and screws.

Folding the Handle

Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1. Loosen the handle knobs until you can move the upper
handle freely (Figure 42).
Figure 42
2. Fold the upper handle forward as shown in Figure 43.
Figure 43
3. To unfold the handle, reverse the steps above.
Removing the Mower from
Storage
1. Remove the spark plug and spin the engine rapidly using
the starter to blow the excess oil from the cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N⋅m).
3. Connect the wire to the spark plug.
15