DeWalt D55150 Instruction Manual page 6

RISK OF EXPLOSION OR FIRE
It is normal for electrical contacts within the motor
and pressure switch to spark. Always operate the
compressor in a welt-ventilated area free of
combustible materials, gasoline or solvent vapors. If
electrical sparks from compressor come into contact
with flammable vapors, they may ignite, causing fire
or explosion. When spraying flammable materials, locate com-
pressor at least 20 feet upwind from spray area. An additional length
of hose may be required.
Store flammable materials in a secure location away from the
compressor.
Restricting any of the compressor ventilation openings will cause
serious overheating and could cause fire. Never place objects
against or on top of compressor. Operate the compressor in an open
area at least 3 feet away from any wall or obstruction that would
restrict the flow of fresh air to the ventilation openings.
RISK OF ELECTRICAL SHOCK
Your air compressor is powered by electricity. If it is
not used properly it could cause electric shock. Never
operate the compressor outdoors when it is raining or
in wet conditions.
Never operate compressor with guards or protective
covers that are damaged or removed. Repairs by anyone other than
qualified personnel can result in serous injury or death by
electrocution. Any electrical wiring or repairs required on this product
should be performed by authorized service center personnel in
accordance with national and local electrical codes.
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding provides a
path of least resistance for electric current to reduce the risk of
electric shock. This tool is equipped with an electric cord having an 2
equipment-grounding conductor and grounding plug. The plug must
be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances. Do not
modify plug provided: if it wilt not fit the outlet, have the proper outlet
installed by a qualified electrician.
Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. The conductor with insulation having
an outer surface that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or replacement of the
electric cord or plug is necessary do not connect the equipment-
grounding conductor to a live terminal.
If the grounding Instructions are not completely understood or if in
doubt as to whether the tool is properly grounded, check with a
qualified electrician or service personnel.
Use only 3-wire extension cords that have 3-prong grounding plugs
and 3-pole receptacles to avoid overheating.
REPAIR OR REPLACE DAMAGED OR WORN CORDS IMME-
DIATELY.
THE USE OF A GFCI OUTLET IS RECOMMENDED AND MAY BE
REQUIRED IN CERTAIN AREAS.
Grounded tools intended for use on a supply circuit having a nominal
rating tess than 150 volts: This tool is intended for use on a circuit
that has an outlet that looks like the one illustrated in Figure A. The
tool has a grounding plug that looks like the plug illustrated in Figure
A. A temporary adapter, which looks like the adapter illustrated in
Figures B and C, may be used to connect this plug to a 2-pole
receptacle as shown in Figure B if a properly grounded outlet is not
available. The temporary adapter should be used only until a