Table of Contents
Advertisement
Operating Your Camera
1) ... When the SPECIAL menu screen is displayed, press the Function Setup switch so that
the arrow indicates 'PRIVACY'.
... ... 2) ... Set up the mode using the Function Setup switch.
- AREA
: You can select up to 12 PRIVACY areas.
- MODE
: Determines whether to use the area selected in the AREA.
- MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White,
Gray.
- MASK TONE : Adjust the brightness of MASK COLOR.
- TOP/BOTTOM/LEFT/RIGHT : Adjust the size and position of the selected area.
- RETURN
: Select this to save the PRIVACY menu settings and return to the
SPECIAL menu.
COMM ADJ (Communication Adjustment) :
This function sets up the camera communication status when controlling the
camera through an external control device.
... 1) ... When the SPECIAL menu screen is displayed, press the Function Setup switch so
that the arrow indicates 'COMM ADJ'.
... ... 2) ... Set up the mode using the Function Setup switch.
- CAM ID : Determines the camera's identification
number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/1920
0/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD
for the parity bits.
- RET PKT : Determines whether to send a command
back to the controller device when a
communication control command is sent to the camera.
- DISP ID : Display camera title on top left corner of the screen.
- PROTOCOL : Select the communication PROTOCOL.
(STW1, STW2, PELCO-D, PELCO-P, BOSCH, HONEYWELL, VICON and PANASONIC)
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL
menu.
* Initial value of communication adjustment
Item
Camera ID
BAUD RATE UART MODE
Initial value
1
9600
34
COLOR DOME CAMERA
PET PKT
8-NONE-1
ENABLE
User Guide
Notes
• As below, the names of protocol have been changed.
- STW(SPD) → STW1
- SEC → STW2
LANGUAGE : You can select the menu language according to your requirements.
RETURN
: Select this to save the SPECIAL menu settings and return to the MAIN
SETUP menu.
EXIT
Select a desired EXIT mode using the Function Setup switch depending on the camera
purpose.
- SAVE
: Save the current settings and exit the MAIN SETUP menu.
- NOT SAVE : Do not save the current settings and exit the MAIN SETUP menu.
- RESET
: Resets the camera settings to the factory defaults. Communication,
Language and Monitor settings are not initialized.
COLOR DOME CAMERA
35
User Guide
Advertisement
Table of Contents
