Voip Call Functions; Activating Voice Over Ip; Placing Voice Calls; Receiving Voice Calls - Net1 R-90 User Manual

R-90 Series
5

VoIP Call Functions

Note: Your router's CDMA and VoIP accounts must be properly activated for VoIP call functions to work. To
setup your wired, landline phone for VoIP calling, plug the phone's RJ-11 cable into the "Line" port on your
router as shown below. Consequently, you must first disconnect the phone from the fixed phone line, and
connect it to the router instead.

5.1 Activating Voice over IP

In order to use Voice over IP you must have an account with Net1. If you do not have the service please
contact Customer Service.

5.2 Placing Voice Calls

1. Turn on the router.
2. Lift the handset from your phone.
3. When you hear a dial tone, use the phone's numeric keypad to dial the desired phone number

5.3 Receiving Voice Calls

The telephone(s) connected to the router will ring when receiving an incoming call.
1. Lift the telephone's handset to answer a call.
Note: To answer an incoming call while you are holding the receiver, press any key on the phone's numeric
keypad.

5.4 Call Forwarding

Call forwarding allow you to forward calls to another number, if you are not available. To enable call
forwarding please follow the instructions below
1. Call Forwarding Unconditional - <*><2><1><*><0><number><#>
2. Call Forwarding No Answer - <*><6><1><*><0>< number ><#>
3. Call Forwarding Busy <*><6><7><*><0>< number ><#>
33