Instructing The Users; Users Safety Guide - andrews OFS25 Installation Manual, Operation And Service Manual

SECTION 4
INSTRUCTING
THE USERS
USERS
SAFETY
GUIDE
22
COMMISSIONING
When satisfactory commissioning and testing has been achieved, hand this manual to the
user or purchaser and explain the method of economic and efficient operation.
Explain that:
1. Other than for long shutdown periods, the heater must be left operating normally.
2. It is important that the control thermostat is set at the lowest temperature consistent
with the user's needs.
Ensure that the user or purchaser is fully conversant with the lighting, shutdown and
general operating procedures.
Advise that any air vents must be kept clear and items must not be placed or stored in
the vicinity of the heater.
Advise of precautions necessary to prevent damage to the heater and systems in the
event of the system remaining inoperative during frost conditions.
Advise the user or purchaser that for continued efficient and safe operation of the heater,
it is important that magnesium anodes are inspected annually and that adequate servicing
is carried out at regular intervals by the installer.
For your safety read before lighting the appliance
WARNING
1. Always follow manufacturers instructions when lighting the appliance. Failure to
do so may result in damage to property, personal injury or loss of life.
WARNING
Hotter water increases the risk of scalding. Before changing the temperature refer
to instruction manual or data label. Hot water can produce third-degree burns in:
6 seconds at 140ºF (60°C)
30 seconds at 130°F (54°C)