Disengaging The - Husqvarna ST 111 Operator's Manual

Engaging the Auger Blades
1. To engage the auger blades, hold the control bar against
the handle (Figure 13).
1
Figure 13
1. Control bar
Disengaging the Auger Blades
1. To disengage the auger blades, release the control bar
(Figure 14).
Figure 14
1. Control bar
OPERATION
IMPORTANT: During initial operation there may be wear
between the auger blades and the scraper bar. Maximum
performance, both snow throwing and driving, occurs
when there is zero clearance between these two parts
(Figure 15).
During initial break-in period of the auger blades it
is normal for the auger blades to build up excessive
heat if not operated in the snow.
Do not operate without snow or water for lubricating
the auger blades. This will cause excessive heat
build up in the auger blades which could cause
damage to the auger blades and scraper bar.
1
Stopping the Engine
To stop the engine, pull key out (Figure 16).
11
1
2
Figure 15
1. Rub Area
1
Figure 16
1. Key
2. Wear Areas