Gemini MDJ-1000 Operation Manual page 9

released the track will resume from the position it would have been if the Loop was
never triggered.
18. FILTER. Use this knob to apply a High/Low Pass Filter on the controlled deck.
19. SLIP. Use this button to enable/disable Slip mode. When Slip mode is active,
several operations (such as Scratching, HotCues, Loop, pause etc.) will be applied
temporary and the track will resume to the position it would have been if the
operation was never triggered.
20. START/STOP TIME. Adjust the time that the track will need to start or stop. If set to
the minimum position, the track will start/stop instantly.
21. SCRATCH. Press this button to set the Jogwheel to Vinyl (Scratch) or CD (Bend)
mode. In Vinyl mode, use the outer part of the Jogwheel to bend (temporary speed
up – slow down the tempo of the track).
22. KEYLOCK. Press this button to "lock" the track's pitch to its original key. The track's
tempo will remain at the speed designated by the Pitch Fader
Hold SHIFT down and then use this button to cycle the 4 Autocue modes
(determines on which position the track will be loaded)
23. BPM TAP/LOCK. Tap this button (for at least 4 times) based on the rhythm of the
track to manually adjust the tempo of the track (if incorrectly calculated by the
software). When track is paused, tap this button once to move the Beatgrid anchor to
the current position.
Hold SHIFT down and then use this button to lock the software Pitch faders of all
the available decks so that they move all together if any of them is moved.
24. PITCH BEND. Press and hold down these buttons to temporary speed up/slow
down the song while pressed. When released, the track playback will return to the
speed designated by the Pitch Fader.
Hold SHIFT down and then use the left button to select the next available range for
the Pitch. The selected pitch range value is displayed on the LCD screen.
25. PITCH. Adjust the track's playback speed (tempo). The pitch value in % and the
current tempo value (BPM) are displayed on the LCD screen
Note. The actual pitch fader will not alter the pitch of the track if the actual pitch and
the software pitch value do not match (software soft-takeover, ghost fader visible on
the GUI). In most cases this may happen if SYNC is prior pressed.
26. BROWSE/SELECT. Use this encoder to scroll through files or folders (depending on
the focused Browser window)
VirtualDJ 8 – Gemini MDJ-1000
9