Gemini MDJ-1000 Operation Manual page 8

Hold SHIFT down and then use the right button to manually set this deck as
MASTER deck (useful mainly in multi-decks operation. All other decks will sync to
the MASTER deck)
11. TRACK SEARCH. Use the right TRACK SEARCH button to load the next track
from the Browser to this deck. Use the left button to stop the loaded track to its
beginning or load the previous track from the Browser to this deck, if the track is
already at its beginning.
12. REVERSE. Use this button to play the track in reverse. Once disabled, the track
will continue to play at the normal direction from the current position. If Slip mode is
enabled, the track will return to the position it would have been if the reverse was
never used.
13. HOTCUES. Each one of the 4 numbered buttons assigns a Hot Cue Point (1 to 4) or
returns the track to that Hot Cue Point.
When a Hot Cue Button is unlit, you can assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is assigned, the Hot Cue Button will light. To
return to that Hot Cue Point, simply press it.
Hold SHIFT down and then press a button to delete its assigned HotCue.
14. LOOP IN. Use this button to set a Loop In (Entry) point of a manual loop.
If a Loop is enabled press this button to set the Jogwheel to Loop In mode and
then use the jogwheel to fine adjust the Entry point of the triggered Loop. The Led
will blink to indicate the selected mode. Press again to return the Jogwheel to Jog
mode.
Hold SHIFT down and then use this button to half the size of the triggered loop in
beats.
15. LOOP OUT. Use this button to set a Loop Out (Exit) point of a manual loop.
If a Loop is enabled press this button to set the Jogwheel to Loop Out mode and
then use the jogwheel to fine adjust the Exit point of the triggered Loop. The Led will
blink to indicate the selected mode. Press again to return the Jogwheel to Jog mode.
Hold SHIFT down and then use this button to double the size of the triggered loop in
beats.
16. RELOOP/EXIT. Use this button to exit a Loop or enable (and jump to the position)
the last triggered one (Reloop)
Hold SHIFT down and then use this button to enable the Loop Roll mode.
17. LOOPS. Each one of the 4 AUTO LOOP buttons triggers a Loop of a different size in
beats (2, 4, 8 and 16 beats) as per the silkscreen of the unit.
Hold SHIFT down and then use these buttons to trigger smaller size Loops (1/8, ¼,
½ and 1 beats).
If the Loop Roll mode is enabled, use the same buttons to trigger a momentary
Loop Roll (while pressed) of the same size in beats as above. When the button is
VirtualDJ 8 – Gemini MDJ-1000
8