Mellanox Technologies BX4000 Series Quick Start Manual page 14

BX 4000 Sereies Quick Start Guide
BOOTPROTO=dhcp
Do you want to save the selected configuration? [Y/n]: (Default "Yes")
Y - will save the new configuration and redirect you to the main menu
N – will redirect you to the main menu
Selection # 2) under the Configure IP Address brings you to this flow. It will show the current configuration
and ask if you want to change it.
2)Static Configuration -
The current IP configuration for eth0 is:
DEVICE=eth0
ONBOOT=yes
HWADDR=<MAC_ADDRESS>
BOOTPROTO=static
Do you want to change this configuration? [y/N]: (Default "No")
N – will redirect you to the main menu
Y – will open the following flow:
Enter an IP Address:
Enter the Netmask:
Start Device On Boot? [Y/n]: (Default "Yes")
After completing these selections the selected configuration will be displayed and you will be asked if you
want to save it.
Selected configuration:
DEVICE=eth0
BOOTPROTO=static
IPADDR=<IP_ADDRESS>
NETMASK=<NET_MASK>
HWADDR=<MAC_ADDRESS>
ONBOOT=yes
Do you want to save the selected configuration? [Y/n]: (Default "Yes")
Y - will save the new configuration and redirect you to the main menu
N - will redirect you to the main menu
Configuration for Host Networking and IP Address
Selection 3 under the config_net brings you to this flow. It will show the current configuration and ask if you
want to change it.
Configuration for Host Networking and IP Address
This selection will open section <1> and section <2> one by one with the flows described above.
Selection 4 under the configure IP Address brings you to this flow. It will show the current configuration and
ask if you want to change it.
Exit
Exit – will exit from the program
Rev 1
Mellanox Technologies
14