Table of Contents
Advertisement
3.
The IR light on the front of the controller will illuminate (red) after pressing "IR Input".
4.
Select the input value you would like to program. In the following factory default example, only
power (ON/OFF) settings are available. Select "Projector Power ON."
5.
Using the projector (or corresponding device's) remote control, press the Power On button while
aiming the remote control's IR emitter at the BRC-4000's IR receiver. Once accepted by the
controller, the LED will blank for a moment and a beep will be emitted.
6.
Continue the process, selecting the "Projector Power OFF" function on the 7" pad and then
inputting the function with the remote control.
7.
Once complete, turn off the BRC-4000 using the front power switch.
Turn the power on once more to utilize the controller again.
www.barosnt.com
21
Advertisement
Table of Contents
