4.
Select the projector brand.
4.
Click the "Power On" button and every other function button once. Clicking these buttons
commits the protocol changes in the controller. You should hear a beep emitted after
each button is clicked.
5.
Once you have clicked and set each function button, you may repeat the process for
Projector 2 if there is one connected.
6.
Following all inputs, turn OFF the controller using the power switch on its front plate.
Power the controller ON once more after a few second's delay. This will save the
protocol changes and reboot the controller.
7.
Disconnect the computer used to update the protocol and reconnect the podium control
pad's RS-232 cable to the KEYPAD port. Turn off the computer's Com Port.
www.barosnt.com
17