Basic Control Panel Programming; Create The Master User Code - Linear Security DUAL 824 Installation & Programming Instructions

7.

BASIC CONTROL PANEL PROGRAMMING

✦ In a new installation, when power is fi rst
applied the system's master user code is
"1234".

CREATE THE MASTER USER CODE

✎ NOTE: Local programming must be entered on
the system's hardwired keypad, not on a wireless
keypad.
1. Press (clears keypad if any other keys have
been pressed).
2. Place the system in Test Mode (enter 1234 and
press TEST.
✴ A "gong" and four "beeps" will sound.
3. Enter the Setup Mode from Test Mode, enter
1234 then press TEST again.
✴ A "gong" and fi ve "beeps" will sound. The system is now
in Test Mode.
4. Enter 99 then press HOME.
5. Enter any combination of 1-5 digits for the master
user code, then press AWAY.
✎ NOTE: For maximum security, a three to fi ve digit
code is recommended.
6. Press and hold the OFF key for 3 seconds to exit
program mode.
7. Test the new master user code by entering it then
pressing TEST.
8. Log the master user code in the box below.
MASTER USER CODE:
✎ NOTE: The master user code can be used to enter
Setup Mode. The restricted user codes cannot. To
create restricted user codes, see the "Advanced
Programming" section of this manual.
14
ENTERING
SETUP
MODE
START IN OFF MODE
CLEARS
KEYPAD
DEFAULT
MASTER
USER
CODE
1 GONG &
4 BEEPS
(TEST MODE)
DEFAULT
MASTER
USER
CODE
1 GONG &
5 BEEPS
(SETUP MODE)
SETTING A
NEW MASTER
USER CODE
START IN SETUP MODE
PROGRAMMING
STEP #99
ENTERS STEP
NUMBER
NEW
MASTER
USER
CODE
STORES
NEW CODE
HOLD FOR
3 SECONDS
TO EXIT
DONE
SETUP