Quickie Salsa R2 Instructions For Use Manual page 32

5.9.5 Manual Articulating / Elevating Leg rest
To elevate:
Pull the leg rest upwards and stop at the desired height.
The leg rest will automatically lock in the chosen position.
To lower:
Push the release lever slowly forward. The leg rest will
lower the angle. As soon as you release the lever, the leg
rest will be locked in the current position, (Fig.5.55).
WARNING!
Keep hands clear of the adjustment mechanism between
the frame and the movable parts of the leg rest while
elevating or lowering the leg rest.
NOTE: Please refer to Section 7 for details of your
controls
5.9.6 Powered elevating leg rest, (ELR, Fig.5.56) or
articulating leg rest, (ALR, Fig.5.57).
NOTE: Both left and right leg rests can also be operated
simultaneously.
To operate a powered ELR, or ALR leg rest:
VR2 Control:
The actuator buttons can operate any factory approved
actuator. Operation is dependent on what options are
fitted to your wheelchair, (Fig.5.58).
To operate the leg rests, seat tilt, seat lift or backrest
recline:
• Push one of the actuator buttons that has the seat
icon on it to select actuator mode.
• Operate the joystick left or right to select the actuator
required (actuator 1 or actuator 2). Selection is
indicated via the lighting of the red LED adjacent to
the desired actuator button.
• Operate the joystick in the forward or rearward
direction to move the leg rest/seat lift/tilt or recline up
or down.
• Release the joystick when the desired angle is
reached.
• To return to drive mode press the actuator button
again.
CAUTION!
Once the leg rest is fully lifted or in its lowest position do
not hold the joystick in its operat ing position as this could
damage the actuator.
R-net Control
Please refer to your R-net Owner's Manual for
details.
32
SALSAR / SALSA M
2 2
Fig.5.55
Fig.5.57
Fig.5.58
Fig.5.56
Rev.1.0