Quickie Salsa R2 Instructions For Use Manual page 31

5.9.1 Leg rest removal
To swing away the leg rest:
• Depress the retaining catch and swing the leg rest
out, (Fig.5.44).
• Lift the leg rest up and off if removal is required,
(Fig.5.45).
To refit:
• Line up the holes and studs, (Fig.5.46).
• Drop the leg rest into the receiver.
• Push the leg rest inwards until it clicks shut,
(Fig.5.47).
To adjust the angle: (Fig 5.48-5.49).
• Use a 5.0mm Allen key and 13.0mm spanner to
loosen stud A,
• Remove stud B.
• Tilt the receiver until the required hole lines up with
the top hole.
• Refit the stud.
Fig.5.44
Fig.5.46
A B
70°
75°
80°
Rehab Seat
Fig.5.48
5.9.2 Standard Seat Hanger depth adjustment
• Remove both sets of 5mm hanger depth adjustment
bolts, (Fig.5.50).
• Slide both hanger receivers to the desired location,
(Fig.5.51, inset B).
• Replace both sets of depth adjustment bolts, (Fig.5.52).
• Use 20 N/m or 177 in/lb of torque.
Rev.1.0
Fig.5.45
Fig.5.47
Rehab Seat
Fig.5.49
Fig. 5.50
Fig. 5.51
5.9.3 Foot plates
The foot plates may be flipped up to aid entry and exit
from the chair.
WARNING!
Do not use the foot plates to stand on as the full weight of
your body may cause the chair to tip forwards. This could
result in injury and could damage the foot rests.
5.9.4 Adjusting the foot rest length
To adjust the foot rest length remove the bolts/screws on
the foot rest stem as shown in (Fig. 5.53, 70° and 5.54),
Centre Mount), adjust the length to suit. Ensure the bolts/
screws are firmly located and tighten ed prior to use.
NOTE: The internal foot rest stem may require cutting
down in length to allow the foot plate position to be
raised.
Fig.5.53
Fig. 5.52
Fig.5.54
SALSA R / SALSA M
2 2
31