Description - Hilti HDE 500-A22 Operating Instructions Manual

c) This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of experi-
ence and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.

3 Description

3.1 Use of the product as directed
Proper use can be ensured only when the instructions for use of the foil pack are also read and observed.
The tool is designed to dispense the contents of Hilti foil packs in a controlled operation. The HDE 500‑A22 cordless
dispenser is designed exclusively for use with Hilti 330 ml or 500 ml foil packs. Use of third-party products with the
tool is not permissible.
Depending on the type of foil pack, the tool can be used with either a black or a red foil pack holder (see fig. 2).
Black foil pack holder: Used to dispense Hilti mortars supplied in black or white foil packs.
Red foil pack holder: Used to dispense Hilti mortars supplied in red foil packs.
The appliance is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
appliance and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when
used not as directed.
Do not use the battery as a power source for other unspecified appliances.
To avoid the risk of injury, use only genuine Hilti tools and accessories.
Observe the national health and safety requirements.
3.2 Standard equipment includes
1 The appliance
1 Operating instructions
1 Foil pack holder, black (optional)
1 Foil pack holder, red (optional)
3.3 Additional items required for operating the tool:
A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from
the C 4⁄36 series.
3.4 Charge state and overheating indicator display on the Li-ion battery
The Li-ion battery features a charge status display. The charge status is indicated by the LEDs on the battery during
charging (please refer to the operating instructions for the charger). When the battery is not in use, pressing one of the
battery release buttons or inserting the battery into the power tool causes the battery charge status to be displayed
by the four LEDs for three seconds.
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
-
2.2.4 Personal protective equipment
a) Wear personal protective equipment while the
tool is in use: closely fitting protective glasses
or face shield, protective gloves and protective
clothing. Wearing personal protective equipment re-
duces the risk of injury.
b) Persons in the immediate vicinity must also wear
personal protective equipment while the tool is in
use.
LEDs blink
-
-
-
-
LED 1
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
The battery has overheated
en
13